Resources
The TS2 can be used to monitor supply (discharge) air temperature or return air temperature. It uses a 10k ohm NTC thermistor sealed in the end of a 6-inch stainless steel tube that protrudes into the plenum or duct. Rubber gasket and hardware is included.
The TS3 can be used to monitor outdoor air temperature. It uses a 10k ohm NTC thermistor sealed in the cover.
The cover can be removed for installation and connecting the two sensor wires to a thermostat cable using wire nuts.
The PS2 is used to monitor the duct pressure when using non-calling zone dampers for bypass. The pressure is read and displayed at the panel and if the duct pressure exceeds the limit, the non-calling zone dampers open just enough to keep the pressure within the limit.
Resources
Resources
PS2 - Duct Pressure Sensor
TS2 - Discharge Air Temperature Sensor
TS3 - Outdoor Temperature Sensor
Compatible with all ProZone Zoning Panels
SW01 - Vacant/Occupied Wall Switch
The SW01 is used to select the vacant or occupied operating mode and connects to the panel.
Resources
The PDMi3 has an 18-inch cable that plugs into any ProZone zoning panel. It can be used to clone a panel, program the options, display the status of the panel, HVAC system, thermostats, dampers and sensors. the PDMi2 can also be used to test an installation.
PDMi3 - Programming and Display Module
Plug and Play Cables with Inline Coupler
Compatible with all ProZone Zoning Panels
Compatible with all ProZone Zoning Panels
Compatible with all ProZone Zoning Panels
Compatible with all ProZone Zoning Panels
FREE to
Qualified Contractors
Model PIC25
Plug and Play, 25-Foot Cable
Model PIC50
Plug and Play, 50-Foot Cable
The PIC50 is a 50-foot plug and play cable that can be used to replace the 25-foot cable supplied with each play and play damper or extend the 25-foot cable furnished with each plug and play damper to 75 feet using the cable and inline coupler.
Compatible with all ProZone Zoning Panels
26072 Merit Circle #110 / Laguna Hills, CA 92653 949-916-0945 / Fax 949-458-8502
eControls
Make sure you're viewing the latest version of our website by clicking the refresh button on your navigation bar.